Kinook Software Forums

Go Back   Kinook Software Forums > Visual Build Professional > [VBP] General Discussion

Thread Tools Rate Thread Display Modes
Old 05-30-2007, 03:51 PM
Buildboy Buildboy is online now
Registered User
Join Date: 12-07-2006
Posts: 12
Resume after Rebooting the system

Hi All
After I install our product in some cases I need to reboot the system, but there are still scrips remaining to be executed after install, is there a was to continue running the rest of the steps after reboot is completed?
I searched the forum but didn't have much luck. any help is greatly appreciated.
Reply With Quote
Old 05-31-2007, 07:13 AM
kinook kinook is online now
Join Date: 03-06-2001
Location: Colorado
Posts: 5,752
A few options:

1) Save the build status in the project file and exit the build at the reboot point. When the project is built again, it will continue with uncompleted steps. At the end of the build, save the project without build status so it starts at the beginning the next time. See for ideas.

2) Use a conditional build rule for the pre-reboot group of steps, building only if some macro is defined. At the point where a reboot is required, create that macro (as a global macro) and exit the build. At the end of the build, delete the global macro so the build starts from the beginning the next time.

3) Break the build into two separate .bld projects. Build the first one when doing a full build (chaining to the second if a reboot is not needed), and the second one when starting from a reboot after the first finished.
Reply With Quote

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

All times are GMT -5. The time now is 09:51 PM.

Copyright 1999-2019 Kinook Software, Inc.