Kinook Software Forums

Go Back   Kinook Software Forums > Visual Build Professional > [VBP] Third Party Tools

Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 07-08-2008, 09:08 AM
tan125 tan125 is online now
Registered User
Join Date: 08-30-2007
Location: PA
Posts: 15
Send a message via Yahoo to tan125
ClearCase rebase


I'm trying to run a ClearCase step to rebase to a set of baselines that isn't recommended. I'm using the -baseline option, but can't seem to get the syntax right when specifying more than one baseline. I tried -baseline [baseline1, baseline2, baseline3, ...] with both square and curly brackets to no avail. I've also tried putting the @VOBselector after each baseline. Again, no luck. Any ideas?
Reply With Quote

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

All times are GMT -5. The time now is 12:31 AM.

Copyright 1999-2019 Kinook Software, Inc.