|
|
#1
03-03-2010, 04:38 PM
|
|||
|
|||
|
Temp macros left over from previous script
I'm having problems with creating a new script.
I launch VBP v.7, the last opened script gets loaded (it's configured so). I click Files/New. I want to create a new script. A blank page appears. So far so good. I create a simple script. When I launch it on the very first step which is GROUP I'm asked to enter a value for temp macros which were used in my last script before I created this new one. I asked my co-worker to run my script. No problems observed. Everytime when I try to create a new script from a scratch I'm facing this problem. I went through all my script to figure out who/which step creates these temp macros - nothing. It really bothers me. thank you 
|
|
#2
03-03-2010, 04:52 PM
|
|||
|
|||
|
Sounds like a non-existent macro is being referenced somewhere (maybe in a global log file setting [Tools | Application Options | Logging] or global script event).
http://www.kinook.com/VisBuildPro/Manual/loggingopt.htm http://www.kinook.com/VisBuildPro/Ma...riptevents.htm http://www.kinook.com/VisBuildPro/Ma...ripteditor.htm http://www.kinook.com/Forum/showthre...?threadid=3044
|
 |
|
|
Linear Mode
