Kinook Software Forum

Go Back   Kinook Software Forum > Visual Build Professional > [VBP] General Discussion
FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 02-14-2013, 06:59 PM
deramor deramor is online now
Registered User
 
Join Date: 05-11-2011
Posts: 27
Set Next Statement command

I find that while debugging, I need to run a small section of a build a few times to test it. In order to rerun the section, I need to get the next statement arrow to move. I usually get this to move by running a step prior to the section I want to debug then stepping through my new steps.

I know in Visual Studio debuggers, they allow you to set the next statement that gets executed. Is it possible to do this here as well? Maybe not while a build is running/paused. Even having the ability to move the pointer when the build is stopped is a benefit.
Reply With Quote
  #2  
Old 02-14-2013, 09:02 PM
kinook kinook is online now
Administrator
 
Join Date: 03-06-2001
Location: Colorado
Posts: 6,034
See the Build from Cursor / Start from Cursor commands, or Rebuild Step Group.
http://kinook.com/VisBuildPro/Manual...ofbuilding.htm
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT -5. The time now is 06:18 PM.


Copyright © 1999-2023 Kinook Software, Inc.