Kinook Software Forum

Go Back   Kinook Software Forum > Visual Build Professional > [VBP] General Discussion
FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 03-06-2003, 09:46 PM
james_cline james_cline is online now
Registered User
 
Join Date: 01-22-2003
Posts: 7
Failure steps are not being called.

I have some failure steps setup but they are not called when IgnoreFailure is set, is thre way to have a step fail and call the failure step but still continue building following steps?

What I am doing is logging everything but also logging failures to a separate file by using the failure steps. This works great unless the step has IgnoreFailure set. I guess what would help is if there were a way to tell it to continue after failure. So that it would not ignore the failure but continue building after processing failure steps.
_
-Jim
Reply With Quote
  #2  
Old 03-06-2003, 09:47 PM
kinook kinook is online now
Administrator
 
Join Date: 03-06-2001
Location: Colorado
Posts: 6,034
The failure steps will not get executed if Ignore Failure is checked. What you could do is put these "partial" failure steps in a subroutine, and then call that subroutine in a step after the step(s) that might fail, conditionally building that Subroutine Call step only if %LASTSTEP_STATUS% is not equal to 0.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT -5. The time now is 05:48 PM.


Copyright © 1999-2023 Kinook Software, Inc.