Hello,
I thought I had posted in the VBP forum, as that is probably this belongs.
The GUIDs are being rolled by Visual Builder Pro in the build steps outlined. However, it appears that Visual Builder Pro is only setting the GUID from the new .ocx in the .vbp (dot vbp is the visual basic project file). Visual Builder Pro is NOT setting the GUID for the OCX in the .frm (Visual Basic form) file.
Said another way, after the build the Visual Basic .frm file still has the old GUID.
Therefore, after the VBP build, there is mis-matched GUIDs.
The secondary question and far less important is 'why doesn't Visual Basic care?'
So, my question is: Why after the build does Visual Builder Pro not update the GUID in the .frm file?
Thanks,
Sheryl
|