Copy Files action sometimes results in corrupt file
Hello-
I am using VBP 8.7. I have recently run into problems with build output files getting copied to a network share. The issue manifests itself in VBP as a failure to copy a file with the error "Access Denied". The build was trying to copy a file to a place where the previous build was. Each build overwrites the previous output.
In the past, I noticed there is some level of retry logic if a file can not be accessed that the Copy Files step employs. According to my help desk people, the issue was that the file about to be replaced was open by a user. Normally I would expect the copy command to enter its retry logic and eventually fail.
Instead what happened was the copy command proceeded and later failed. This left the file in a corrupt state and I couldn't delete or rename it. Its user rights were just gone.
My question is, how does VBP copy files? Is is the VB script:
' Copies a file
Sub vbld_CopyFile(SourceFile, DestFile, Overwrite)
' ensure that the target file is not read-only
If OverWrite Then vbld_MakeFileWriteable DestFile
' copy
vbld_FSO.GetFile(SourceFile).Copy DestFile, Overwrite
End Sub
What triggers the retry logic?
Do you have an suggestions as to server settings that can help eliminate this issue?
|