Kinook Software Forums

Kinook Software Forums (http://www.kinook.com/Forum/index.php)
-   [VBP] General Discussion (http://www.kinook.com/Forum/forumdisplay.php?f=2)
-   -   Failure steps are not being called. (http://www.kinook.com/Forum/showthread.php?t=13)

james_cline 03-06-2003 09:46 PM

Failure steps are not being called.
 
I have some failure steps setup but they are not called when IgnoreFailure is set, is thre way to have a step fail and call the failure step but still continue building following steps?

What I am doing is logging everything but also logging failures to a separate file by using the failure steps. This works great unless the step has IgnoreFailure set. I guess what would help is if there were a way to tell it to continue after failure. So that it would not ignore the failure but continue building after processing failure steps.
_
-Jim

kinook 03-06-2003 09:47 PM

The failure steps will not get executed if Ignore Failure is checked. What you could do is put these "partial" failure steps in a subroutine, and then call that subroutine in a step after the step(s) that might fail, conditionally building that Subroutine Call step only if %LASTSTEP_STATUS% is not equal to 0.


All times are GMT -5. The time now is 12:04 AM.


Copyright 1999-2019 Kinook Software, Inc.