Kinook Software Forum

Kinook Software Forum (https://www.kinook.com/Forum/index.php)
-   [VBP] General Discussion (https://www.kinook.com/Forum/forumdisplay.php?f=2)
-   -   Store exit code in temporary macro (https://www.kinook.com/Forum/showthread.php?t=5301)

innomatics 09-23-2014 10:59 PM

Store exit code in temporary macro
 
I would like to be able to store the exit code of the program command in a temporary macro during a build step.

This is so I can decide, based on the exit code whether to execute a future step.

For example, an installation returns with code 3010 to signal the install succeeded, but a reboot is required. I have added this exit code to the Success exit codes which is fine, but I think I need to set the temp macro to the exit code value in the post step event. Is this possible?

kinook 09-24-2014 05:47 AM

Either

1) In the step's vbld_StepDone script event, store the value like so:

Code:

vbld_TempMacros.Add "TEMP_EXIT_CODE", vbld_TempMacro("RUNPROGRAM_EXITCODE").Value
http://www.kinook.com/VisBuildPro/Ma...riptevents.htm
http://www.kinook.com/VisBuildPro/Ma...gramaction.htm
http://www.kinook.com/VisBuildPro/Ma...scriptmisc.htm

or

2) Add a Set Macro step following the step that runs the program and set a temp macro's value to %RUNPROGRAM_EXITCODE%

http://www.kinook.com/VisBuildPro/Ma...acroaction.htm

innomatics 09-24-2014 06:35 PM

Thanks very much :)


All times are GMT -5. The time now is 06:17 PM.


Copyright © 1999-2023 Kinook Software, Inc.